ПРА-499. Правильно-отрезной автомат в Москве

Станок ПРА499
предназначен для разматывания, правки и мерной резки горячекатаной круглой стали гладкого и периодического профиля диаметром от 5 до 16 мм. кл. А-I; А-II; Ас-II и А-III по ГОСТ 5781-82. Допускается правка проволоки диаметром 4 мм по ГОСТ6727-80 при изготовлении дополнительного инструмента по требованию заказчика за дополнительную плату.
Диаметр обрабатываемых стержней
гладкого профиля 5...16 мм
периодического профиля 5...12 мм
Скорость правки 30; 45 * м/мин
Длина отрезаемых стержней 0,19**м
Допустимое отклонение длины отрезаемых стержней 9 мм
Установленная мощность 36 кВт
Габаритные размеры 12140x1535x2000 мм
Габаритные размеры 1 секции приемного устройства 2250x
Масса ПРА-499 5400 кг
ПРА499А designed for unwinding, straightening and cutting dimensional hot-rolled round steel smooth and periodic profile with a diameter from 5 to 16 mm. KL. A-I; A-II; AC-II and A-III GOST 5781-82. Allowed edit of wire with a diameter of 4 mm ГОСТ6727-80 in the manufacture of an additional tool at the request of the customer for an additional fee. Automatic straightening-cutting is equipped with the unwinding and receiving devices. The receiving device has a measuring mechanism, allowing a blank of the required length. Straightening and cutting machine ПРА499 AND is right off machine with rotating the right frame, roller flow and lever cutting. Feed drive and cutting ПРА499 AND is made from two-speed electric motor through V-belt transmission. Edit material is in the guide sleeves and in the right frame in all planes by multiple transverse plastic bending portages comp enshrined in the breadcrumbs, which are installed in the correct sockets-rotating frame. To adjust the clearance between the lower and upper feeding rollers depending on the size of the cross section of the material axis roller is made eccentric. Drive the correct frame from the electric motor through V-belt transmission. Cut lengths of bar straightening-cutting machine is with a cutting sleeve, mounted in the housing rear of the feeder and the open knife mounted on duplicem the lever, freely swinging in the axis. Died of cut length of bars, manufactured through the measuring mechanism, which is installed in the receiving device. Cut bars from the channel of the receptor are discharged downwards. Technical characteristic: the Diameter of the rods, mm: smooth profile 5...16 periodic profile 6...12 feed Speed, m/min 30, 60 Length of sticks, mm 500...12000 Permissible deviation of the length of sticks, mm +15, the Number of pairs of feed rollers 2 the Number of correct bushings in the correct frame of 5 overall dimensions, mm, length, width, height 20600х1690х1855 Weight, kg: 3210 Rhode mains current Alternating three-phase Motor of the feed drive and cutting: type АИР132 M6/4 U3 power, kW 6,7/7,5 speed min-1 1000/1500 a Motor of the correct frame: type 4А132М4У3 power, kW 11 rotational frequency, min-1 1500 total power of motors, kW 18,5